Jack Vigil 
If you’re trying to remove a screw that is stuck, there are a few things you can try. First, try using a different screwdriver. If that doesn’t work, try heating up the screw with a soldering iron. You can also try using a impact driver. If none of these work, you may need to drill … Read more
Assuming you want to bypass the Honda main relay: One way to do this is to disconnect the relay from its socket and connect the two large terminals on the relay together with a jumper wire. This will bypass the relay and should allow the car to start. 4 Steps to Bypass A Honda Main … Read more
If you’re looking to add a unique touch to your car, or simply want to protect your rims from the elements, then plasti dip is a great option. Here’s a quick guide on how to plasti dip rims. First, clean the rims with soap and water to remove any dirt or grime. Next, apply a … Read more
One possible fix for a trunk latch that won’t close is to check the alignment of the latch. It’s possible that the latch is not lined up correctly with the strike plate, which is preventing it from closing properly. If the latch and strike plate are not aligned, you can try gently tapping the strike … Read more
When a car’s turn signal is used, the bulb flashes rapidly to indicate to drivers in other vehicles that the car is about to turn. This is done by sending more electricity to the bulb than it is rated for, which makes it “hyper flash.” To fix this, you can install a resistor in the … Read more
The most common symptom of a bad motor mount is engine vibration. The engine will feel like it is shaking or wobbling, and this can be amplified by the transmission. Another symptom is that the engine will seem to move when the vehicle is idling in park or neutral. This is because the motor mount … Read more
Installing a valve cover gasket is a relatively easy task that can be completed in a short amount of time. The first step is to remove the old gasket from the valve cover. Next, clean the surface of the valve cover to ensure that the new gasket will adhere properly. Once the surface is clean, … Read more
There are a few things you need to take into account when adjusting the dampening on your coilovers. First, you need to decide what kind of driving you’ll be doing most often. If you’re mostly going to be on the street, you’ll want a softer setting. If you’re going to be hitting the track, you’ll … Read more
There are a few things you will need in order to change your shift knob: a new shift knob, a ratchet, an extension, and a socket. The first step is to remove the old shift knob. To do this, you will need to unscrew the shift knob from the shifter. Next, you will need to … Read more
If the e-brake is stuck, the first thing to check is the fuse. If the fuse is blown, replace it and try again. If the fuse is not blown, check the e-brake cable for damage. If the cable is damaged, replace it. 3 Steps to Get E Brake Stuck There are a few things that … Read more
